Page 7 - QR CIMAR PADDLE MIXER

3. When towing, always make sure the Tow Chains (17) are properly attached to the towing vehicle. Make
sure Tow Shaft (16) is secured tightly into place. Refer to the vehicle manufacturer’s instruction manual for
proper towing instructions. (See Figure C.)

OPERATION

1. Make sure the Engine of the Mortar Mixer is filled with the proper amount of oil and unleaded
gasoline or diesel as recommended by the Engine manufacturer before attempting to start the
Engine. Failure to do so WILL damage the Engine and void the warranty. (See Engine manufacturer’s
instruction manual.)

2. First, after making sure clutch is disengaged, place the Mortar Mixer on a solid, flat, level, dry ground
surface.

3. Start the Engine, and allow it to reach the appropriate operating temperature as instructed in the Engine
manufacturer’s instruction manual.

4. NOTE: Filling and emptying the Drum (55) of the Mortar Mixer is best done with the Drum rotating. To
rotate the Drum, turn the Clutch Lever (19) to the right. Do not turn off the Mortar Mixer while full of cement.
(See Figure D.)

5. With the Drum (55) operating between 20 to 36 RPM, the Mortar Mixer is now ready for the addition of the
concrete mix.

6. To determine the proper amount of water, gravel, cement, and sand, refer to the following Table. (See
Figure E.)

7. For best results, proceed as follows:
 Pour the required amount of water into the Drum (55).
 Add the required amount of gravel into the Drum (55).
 Add the required amount of cement into the Drum (55).
 Add the required amount of sand into the Drum (55). (See Figure E.)

Page 6 of 10