Page 120 - QR KLINDEX EXPANDER850AT-RXt

OPERATION

8.5 Assembly and changing tools – move onto the stand and using your body weight,
pull the handlebar towards you until the appliance
l WARNINGS lifts up completely
– Before performing any operation on the
appliance, make sure that the main dial
is set to “OFF” and the power cable is
disconnected.

– Before fitting or changing the tools,
make sure that the handle grip and cast-
er wheel are both inserted and locked.

l NOTICE – when the appliance is fully raised, rest it carefully on
Before fitting the tools, make sure you the floor as shown in the figure.
have read and fully understood the indica-
tions provided in the section "Identifying a WARNING
the hardness of the concrete" on page Make sure that the appliance is in a stable
28 and that you have selected the most position before carrying out any type of
appropriate tool for the operation to be intervention.
carried out. To select the correct tool, see To facilitate appliance lifting operations, the
the section "Tool selection" on page 28. weight kit can be used, positioning it in the rear
support as described in the section "Weights kit
Lifting the appliance (optional)" on page 19.
To assemble and replace the tools, act as described
below:
– lower the appliance fully acting on the lever switch

on the control panel
– remove the caster wheel, see the section "Fitting/

removing the caster wheel" on page 17
– lift the handlebar (1) until it reaches the position for

interventions on the planets as described in section
"Fitting and adjusting the handle grip" on page
18
– release the fastening pin (3) and lower the stand (2)
completely

1
3

2

30 www.klindex.com - Made in Italy