Page 18 - Genex EN76 Installation Manual - Issue 05.03.2020

Issue: 03/12/2019

 Put two uprights at a comfortable
working height side by side on a flat surface,
preferably on an assembly support.

 Be sure that the upright is positioned like
in the left image (eg. With the front slots at
25.6mm from bottom edge and with the back
round holes at 76.2mm from the bottom edge) in
order to allow fixing of the baseplate

 If the uprights include bolted baseplates, these
are bolted now.
 If the uprights include welded baseplate, skip
this point

All screws must be tightened. Tightening
torque: 22 Nm

EN76 Pallet Rack System | 18