Page 22 - Genex EN76 Installation Manual - Issue 05.03.2020

Issue: 03/12/2019

► All screws must be tightened with a torque of 22 Nm.
Sort the finished frames according:

● Type (EN76-90, EN76-100)

● Frame depth (if different)
● Frame height (end frames that are placed at a transport route, are 500mm higher than the
center frames)
● Color (if different)

4.6 Frame set-up

Assembled frames will be raised into position, with beams being fitted at appropriate levels.

The exact sequence adopted will vary according to the style of each installation, e.g. height, access
equipment available, and the phasing, either across or along the rack runs.

Generally smaller low rise installations can be raised manually, whilst larger and taller installations
will need the assistance of specialist lifting equipment such as fork trucks and scissor lifts.

Low frames can be raised manually by two assemblers:

One assembler secures the frame against sliding,
while the other sets up the frame.

In order to raise high frames two assemblers and a forklift are required:

One assembler secures the frame against sliding,
while the other sets up the frame with the forklift.

EN76 Pallet Rack System | 22