Page 1093 - Workshop Manual - Aumark (BJ1051)
P. 1093

51-1
                                           Heater and air conditioner- heater and air conditioner
               Heater and air conditioner

               Notes

               1.     ingnition switch description
                            Ingnition switch (position)                     Ingnition switch description
                                    Lock                                        Ingnition switch off
                                     Acc                                        Ingnition switch acc
                                     On                                         Ingnition switch on
                                     Start                                        Start the engine

               2.     cut off the power
               (a).    Cut off the battery negative pole cable first before removing or installing any electric
                      installation and while the tools or equipment may contact the uncovered electric pin easily so as
                      to avoid damaging the people or vehicles.
               Hint:
               If control central lock is equipped with, don’t leave the keys in the vehicle before disconnecting the
               battery negative cable so as to avoid locking the doors.
               (b).    The ignition switch must be shut off unless it is expressly stated.

               3.     the daily odometer and clock in the combination meter will be cleared to zero after
                      disconnecting the battery negative pole cable
               Hint:
               The master odometer will not be cleared to zero.

               4.     the audio system may lose the settings stored after disconnecting the battery negative pole
                      cable
               Hint:                                                                                                51
               The audio system shall be reset after connecting the battery negative pole cable again. (refer to
               “chinese and english service manual on audio system”)
                                                                5.     don’t operate in an enclosed place or the
                                                                       place near the sources of ignition.














               6.     don’t carry out welding operation on the parts that are filled with refrigerant
               7.     please always put on goggles.

















                                                                                                        Page 1093
   1088   1089   1090   1091   1092   1093   1094   1095   1096   1097   1098