Page 176 - fif

25567_eyal-Y-MK1-837 - 25567_pnim_y-mk1-837_eyal.1.1 | 7 - B | 18-06-11 | 09:03:44 | SR:-- | Cyan
#25567_eyal-Y-MK1-837 - 25567_pnim_y-mk1-837_eyal.1.1 | 7 - B | 18-06-11 | 09:03:44 | SR:-- | Black
25567_eyal-Y-MK1-837 - 25567_pnim_y-mk1-837_eyal.1.1 | 7 - B | 18-06-11 | 09:03:44 | SR:-- | Yellow
25567_eyal-Y-MK1-837 - 25567_pnim_y-mk1-837_eyal.1.1 | 7 - B | 18-06-11 | 09:03:44 | SR:-- | Magenta
#
Appendix 2

ELECTROMAGNETIC COMPATIBILITY Guidance and manufacturer’s declaration – electromagnetic immunity for not life
EMC according to IEC 60601-1-2 ed.4 support equipment
The Product is intended for use in the electromagnetic environment specified below.
®
The ProPex II is intended for use in professional healthcare facility or The customer or the user of the Product should assure that it is used in such an
home healthcare electromagnetic environment specified in this chapter. environment.
®
The customer or the user of the ProPex II should assure that it is used Immunity IEC 60601 Compliance Electromagnetic environment - guidance
in such an environment. tests Test level level
®
Changes or modifications to this ProPex II not expressly approved by Portable and mobile RF communications
equipment should be used no closer to
the manufacturer may result in increased emissions or decreased any part of the Product, including cables,
®
immunity performance of the ProPex II and could cause EMC issues than the recommended separation
®
with this or other equipment. This ProPex II is designed and tested to distance calculated from the equation
comply with applicable regulations regarding EMC and shall be installed applicable to the frequency of the
and put into service according to the EMC information stated as follows. transmitter.
Recommended separation distance:
Use of portable phones or other radio frequency (RF) emitting d = 0.35 √P 80 MHz to 800 MHz
®
equipment near the ProPex II may cause unexpected or adverse d = 0.7 √P 800 MHz to 2.5 GHz
operation. Where P is the maximum output power
®
The ProPex II must not be used adjacent to, or stacked with, other Radiated RF 3 V/m 3 V/m rating in the transmitter in watts (W)
®
equipment. If adjacent or stacked use is necessary, the ProPex II IEC 80 MHz to 80 MHz to according to the transmitter
manufacturer and d is the recommended
must be tested to verify normal operation in the configuration in which 61000-4-3 2.5 GHz 2.5 GHz separation distance in metres (m).
it is being used.
Field strengths from fixed RF
transmitters, as determined by an
a
electromagnetic site survey , should be
less than the compliance level in each
b
frequency range .
Interference may occur in the vicinity of
equipment marked with the following
symbol:

176/184 B EU PIIS DFU PRT / Rev.04 / 02-2018 (Old ZF 1902127.X) B EU PIIS DFU PRT / Rev.04 / 02-2018 (Old ZF 1902127.X) 173/184