Page 63 - PH_Masonry_Final_Ver 1_July 2020

Auto Plastering Machine

SCOPE

This procedure covers the method for plastering work using Auto Plastering Machine

Safety Guidelines:

 Scaffolding : Erected, Inspected, Approved as per Contractor/ Client safety guidelines

 Plastering Machine: Inspected and Approved by P&M department regarding Mechanical and
Electrical Issue along with operator.

 Plastering Pipeline : Mortar Hose and Air Hose should be fixed with existing Scaffolding

 Workmen : All Staff, Operator, Workmen are to be trained regarding operation of the Machine

Materials

1. Sand: This shall be complying with the requirements of IS 383. Zone II & Zone III sand shall

be used. Sand shall be consisting of materials resulting from natural disintegration of rock
and which has been deposited by stream.

2. Cement: The cement shall be Portland Pazzolana Cement/ Ordinary Portland Cement. Test

Certificate of the Cement of each consignment shall be submitted to client

3. Crusher Dust: Crusher Dust is produced from blast furnace slag by crushing, screening and
processing to remove all single size aggregates. The fines are screened off as crusher dust, a

grey coloured fine aggregate dust consisting of angular to roughly cubical shaped particles
with a characteristically vesicular structure and rough surface texture

4. Chemical (Air Entering Agent) : Chryso ARN is used as an air entering agent to make the

mortar flow regular while passing through the mortar hose pipe.

Required Machinery & Tools:

1. Auto Plastering Machine.

2. Mortar Rubber Hose Pipe (40 mm or 50 mm Dia.).

3. Compressor Rubber Hose pipe (25 mm Dia.)

4. Nozzle/Spray Gun.

5. Sand Screening Machine.

6. Plaster Finishing Machine /Rendering Machine.

7. Aluminum Rectangular Strips (10mmx40mm)

8. Aluminum Angle Scraper

Participant Handbook : Masonry 63