Page 1063 - 2006 HARLEY FLSTCI SERVICE MANUAL

2

6

4
5 Figure 8-28. Voltage Regulator Assembly

Deutsch connector Voltage regulator bolt (2) Wire retainer Ground wire Regulator bracket bolt (2)
7 Wire to main circuit breaker

s0489x8x 1 3 1. 2. 3. 4. 5. 6. Bracket 7.

Attach ground wire Verify that ground wire is installed
If installing a new regulator, see Figure 8-27. Attach
Mate Deutsch connector (1) [46]. Clip connector to back
regulator to bracket (1) using two bolts (3). Tighten

(5.6-9.0 Nm). between bracket mounting bolt and bracket (1). Tighten regulator bracket bolt to 70-100 in-lbs (7.9- If regulator and bracket were temporarily removed, see Figure 8-28. Attach assembly to engine using between bolt (6) and bracket (7). Tighten bolts to 70-100 in-lbs (7.9-11.3 Nm). Replace wire retainer (4) if removed and attach to Route wire (3) to silver post on main circuit breaker. Place wire from ignition switch to silver post on main cir- 1WARNING 1WARNING After installing seat, pull upward on front of seat to be sure it is in locked position. While riding, a loose seat can shift causing loss of control, which c

INSTALLATION of mounting bracket. Install regulator. in-lbs to 50-80 11.3 Nm). two bolts (6). bracket (7). cuit breaker and install nut. Connect negative battery cable. or serious injury. (00070a) Install seat. 2006 Softail: Electrical

HOME 1. 2. a. b. 3. 4. 5. 6. 7. 8-24