Page 1059 - 2006 HARLEY FLSTCI SERVICE MANUAL

8.13

4
3
5 Figure 8-23. Main Circuit Breaker Wiring Complete installation instructions under 8.4 ELECTRI- 1WARNING 1WARNING After installing seat, pull upward on front of seat to be sure it is in locked position. While riding, a loose seat can shift causing loss of control, which could result in death

2 Wire from voltage regulator Connect negative battery cable.
1 Wire from ignition switch
Copper stud Wire from starter Silver stud CAL PANEL. or serious injury. (00070a) Install seat.

s0562x8x
1.
2.
5.
4.
3.
3. 4. 5.
8.4 ELECTRICAL
should overload, the bimetallic breaker contacts automatically
open to stop current flow. As soon as the contacts have
See Figure 8-23. The main circuit breaker is on the electrical
panel behind the fender extension. If the electrical circuit
This opening and closing of the breaker contacts continues
cooled down, they automatically close, completing the circuit.
MAIN CIRCUIT BREAKER
as long as the current circuit overload condition exists.
1WARNING 1WARNING prevent accidental vehicle start-up, which could cause death or serious injury, disconnect negative (-) battery cable before proceeding. (00048a) Disconnect negative battery cable. Follow removal instructions under PANEL to gain access to the master circuit breaker. See Figure 8-23. Remove nuts and wires (2, 4, 5) from Pull circuit breaker from electrical panel tabs. See Figure 8-23. Attach wiring using nuts. Place wire from starter (2) on copper stud (1) and Place wire from voltage regulator (5) on silver stud Place wire from ignition switch (4) on silver stud and 2006 Softail: Electri

GENERAL REMOVAL Remove seat. studs (1, 3) on circuit breaker. INSTALLATION Push circuit breaker into tabs. install nut. (3). install nut.

HOME 1. To 2. 3. 4. 5. 1. 2. a. b. c. 8-20