Page 1159 - 2006 HARLEY FLSTCI SERVICE MANUAL

3 5
2 8 1 4
Figure 9-48. End Cap Engaged 10 Figure 9-49. Top Plate Torque Sequence

Fuel pump housing 2

1
End cap 6

s0550x9x 1. 2. 11561 9 7

9.15 FUEL PRES-

CAUTION Exercise care to avoid bending float rod of fuel level sender. A bent float rod will result in erroneous gauge NOTE Fuel pump sits in left side of fuel tank. Fuel gauge sending NOTE Install fuel gauge sender into mounting tabs. Push down See Figure 9-40. Install fuel pump until rubber spacer Install hose and new fuel line clamp on fuel filter fitting. See Figure 9-48. Pivot top plate and push down so end cap (1) engages fuel pump housing (2). See Figure 9-49. Place gasket and top plate on tank. Using the pattern shown, tighten T20 TORX screws to See Figure 9-37. Connect fuel pump module connector Connect console wiring and install c

INSTALLATION unit sits in right side of fuel tank. Do not apply any type of sealant to gasket. Install new gasket under top plate. on sender until it is seated in tabs. rests on bottom of fuel tank. loosely install new sealing screws. 18-24 in-lbs (2.0-2.7 Nm). (3) [86]. clamps (1). wiring harness. Connect negative battery cable. SURE TEST. or serious injury. (00070a) Install seat.

HOME readings. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 9-32