Page 6 - 2006 HARLEY FLSTCI SERVICE MANUAL

1.1 1-1

Table 1-1. Starter Does Not Run or Runs At Very Low Speeds
SOLUTION Clean, tighten or replace cable(s) as needed. Tighten connections or repair or replace wire(s). Check for open on wire to TSM/TSSM. Correct Polish contact surface or replace solenoid Repair or replace solenoid assembly. Repair or replace solenoid assembly. Check brush spring tension. Replace field frame Use recommended viscosity oil for temperature 2006 Softail: Starting & Charging

Charge battery. Replace battery. Clean and retighten. Repair or replace cable(s). Replace switch. Replace relay. Replace relay. lack of ground. assembly. and holder. Re-face or replace. Correct by undercutting. Replace. Replace. Replace. Replace. Repair or replace lead wire. Replace bearing. range. Consult owner’s manual

STARTER TROUBLESHOOTING

PROBABLE CAUSE Voltage drop due to discharged battery. Short-circuited or open between electrodes. Poor contact condition of battery terminal(s). Poor or no connection at either battery positive or negative cable, at either end. Cracked or corroded battery cable ends. Open wire(s) or poor connection at handlebar switch or starter relay, especially relay ground wire. Poor switch contacts or open switch. Open coil winding. Poor or no continuity at relay points. TSM/TSSM has disabled starter relay. Poor contact condition caused by burnt contact. Pull-in winding open or short-circuited. Hold-in win

SOURCE OF PROBLEM Starter relay Starting motor windings. Temperature

HOME Battery Wiring Handlebar start switch Solenoid

5