Page 687 - 2006 HARLEY FLSTCI SERVICE MANUAL

Figure 2-52. Radial Tire Runout Figure 2-53. Lateral Tire Runout Maximum tire tread runout is 0.080 in. (2.03 mm). If tire tread runout exceeds 0.080 in. (2.03 mm), remove tire from rim and check rim bead runout to see if rim is at fault. See 2.12 TRUING LACED WHEEL or 2.13 DISC NOTE Be sure bead is properly seated on rim. Deflate and reseat If rim bead runout is less than 0.030 in. (0.76 mm), tire is at fault and should be replaced. If rim bead runout is more than 0.030 in. (0.76 mm), correct by replacing disc wheel or truing laced wheel. If you turn nipples more than one full turn, rem

d0479x2x d0480x2x RIM RUNOUT. tire if necessary.

2. 3.

stem, start the second bead onto the rim. Work the bead
See Figure 2-51. Starting 180 degrees from the valve
a balance mark and should be located next to valve stem
2.13 DISC RIM
directions. Remove the valve core from the rim hole
onto the rim with tire tools, working toward valve in both
bead into the rim well. Work the bead on as far as possi-
See Figure 2-50. Starting at the valve stem, start the first
the tire with tire lubricant. Install RIM PROTECTORS,
over the rim flange. If tire has colored dot on sidewall, it is
Thoroughly lubricate the rim flanges and both beads of
ble by hand. Use the tire tool to pry the remaining bead
before prying the remaining bead over the rim flange.
(Part No. HD-01289) to prevent scarring rims.
11WARNING 1WARNING Do not exceed manufacturer's recommended pressure to seat beads. Exceeding recommended bead seat pres- sure can cause tire rim assembly to burst, which could result in death or serious injury. (00282a) Inflate the tire to recommended pressure to seat the bead. See 1.9 TIRES AND WHEELS. Use BEAD EXPANDER (Part No. HD-28700) to seat CHECKING TIRE RUNOUT See Figure 2-52. Check runout by turning wheel on axle, measuring amount of radial displacement from a fixed Maximum tire tread runout is 0.090 in. (2.29 mm). If tire tread runout exceeds 0.090 in. (2.29 mm), remove tire from rim and check rim runo

hole. beads on tubeless tires. Radial Runout point near the tire. 2.12 TRUING RUNOUT. tire if necessary. recheck tire tread runout. Lateral Runout measuring tread runout.
HOME 3. 4. 5. 6. 7. 1. 2. 3. 1. 2-38