Page 865 - 2006 HARLEY FLSTCI SERVICE MANUAL

2
1 2
1 Figure 3-106. Install Valve Guide

Valve guide driver Cylinder head stand

Valve guide installer sleeve 3

1. 2. 3. d0169b3x

SPECIALTY TOOL Measure the outside diameter of a new standard Measure the cylinder head valve guide bore. The valve guide should be 0.0020-0.0033 in. (0.051- If clearance is not within specification, then select one of the following oversize guides: 0.001 in. (0.025 Insert sleeve of intake (3) or exhaust (4) seat adapter into tube at top of support stand (2). Position cylinder head so that valve seat is Apply Vaseline to lightly lubricate external surfaces of valve guide. Spread lubricant so that thin film cov-

Valve guide hone Valve guide installer sleeve Valve guide driver Valve guide cleaning brush Cylinder head support stand Cylinder head holding fixture Reamer T-handle Valve guide reamer Check valve guide to valve bore clearance. 0.084 mm) larger than the bore. mm), 0.002 in. (0.05 mm) or 0.003 in. (0.08 mm). NOTE Since some material is typically removed when the guide is pressed out, it is normal to go to the next larger size for the Measure cylinder head bore and outside diameter of selected oversize guide to verify correct interference fit. CAUTION Support stand ensures that valve guide and seat are per- pendicular. If perpendic

Installation PART NO. B-45524-2A B-45524-1 HD-34751-A HD-39782-A HD-39786-A HD-39847 a. valve guide. b. c. proper interference fit. procedure. a. See b. c.

HOME B-45525 B-45523 1. 2. 3. 3-78