Page 937 - 2006 HARLEY FLSTCI SERVICE MANUAL

s0154x2x

2 1
Figure 4-7. Float Bowl Screws 2 Figure 4-8. Carburetor Float Tab
3

Float tab
1
4 Float

7364
1. 2.

Remove the carburetor. See REMOVAL under 4.4 CAR-
Remove four screws to detach float See Figure 4-9. Place the carburetor on a flat, clean sur- face on the engine manifold side. This is the “base”. Tilt NOTE If you tilt the carburetor to less than 15˚ or more than 20˚, Use a vernier or dial caliper depth gauge to measure from the carburetor O-ring flange face to the perimeter of the float. Be careful not to push on float while measuring. See Figure 4-8. If measurement is not within 0.413-0.453 in. (10.49-11.51 mm), carefully bend float tab (1) to posi-

Float Level BURETOR. Figure 4-7. See bowl. the carburetor 15˚ to 20˚ from base. your measurements will be incorrect. tion float at proper level. Install float bowl. See ASSEMBLY. Install carburetor. See INSTALLATION. 2006 Softail: Fuel System

HOME 1. 2. 3. 4. 5. 6. 7. 4-12