Page 935 - 2006 HARLEY FLSTCI SERVICE MANUAL

CAUTION Slow fuel jets from fixed venturi carburetors look the same as the slow jet of the C.V. carburetor. However, the air bleed hole sizes are different on fixed venturi carbure- tors and they must not be installed on C.V. carburetors. See Figure 4-3. Screw slow jet (31) into slow jet passage Turn carburetor upside down. Place needle jet (48) in main jet passage with needle passing through center hole. Be sure end of jet with larger opening and cham- fered surface enters passage first. Insert needle jet holder (47) into main jet passage with needle inserted into center of holder. Thread holder into passage and tighten. Thread main jet (46) into

Carburetor Body 1. with narrow bladed screwdriver. 2. 3. hole in holder and tighten. 4. mounting posts. 5. (45) and tighten. 6. Accelerator Pump lockwashers (41).

See Figure 4-3. Place needle (6) through center hole in vacuum piston (7). Place spring seat (5) over top of nee- Insert vacuum piston into carburetor body. The slides on the piston are off-center and the piston will fit into the slide track grooves only one way. If piston does not fit, Check to be sure diaphragm is seated evenly into groove Place spring (4) over spring seat and carefully lower top (2). Keep spring straight while lowering top. After top is seated, hold top while lifting up on vacuum piston. Piston should rise to top smoothly. If piston move- ment is restricted, spring is cocked. Lift up on top and lower carefully, keeping spr

ASSEMBLY Vacuum Piston Chamber rotate 180 degrees. at top of carburetor body. 2.6 Nm). or throttle cam.

HOME 1. dle. 2. 3. 4. 5. 6. patch. 7. 4-10