Page 995 - 2006 HARLEY FLSTCI SERVICE MANUAL

6.4 6.2 PRI-

under
Regular plate
Figure 6-19. Friction Plates Align holes in diaphragm spring retainer (2) with threaded bosses on clutch hub. Tabs on spring retainer contact flats on inboard side of bosses. Install six bolts (1) (metric) to secure diaphragm spring retainer to clutch hub. Alternately tighten the bolts to 90- CAUTION The gasket between the primary chaincase cover and chaincase must be replaced each time the cover is removed. Failure to replace this gasket may cause pri- Install primary chaincase cover and fill with lubricant. PRIMARY CHAINCASE COVER

Narrow plate 110 in-lbs (10.2-12.4 Nm). mary chaincase leaks. MARY CHAINCASE.

d0354x6x See

7. 8. 9.

PRIMARY 6.2 PRIMARY CHAIN-

REMOVAL/INSTALLATION To remove or install the clutch without disassembly, see 6.3 CLUTCH PACK ONLY This procedure can be performed on the motorcycle without removing the clutch shell or hub. Remove primary chaincase cover. See under CHAINCASE COVER See Figure 6-20. Remove six bolts (1) (metric) to release diaphragm spring retainer (2) from clutch hub. Loosen each bolt gradually and in a star sequence around the Remove diaphragm spring retainer, diaphragm spring (3) and pressure plate (4) from clutch hub. Remove friction plates (5, 7), steel plates (6), damper spring (8) and damper spring seat (9) from clutch hub (11). Continue with CLE

CLUTCH DRIVE COMPONENTS. Partial Disassembly CASE. hub. Assembly shell.

HOME 1. 2. 3. 4. 1. 2. 3. 4. 5. 6. 6-12