Page 997 - 2006 HARLEY FLSTCI SERVICE MANUAL

Follow all partial disassembly information under
Wear safety glasses or goggles when removing or install-
To avoid possible bearing damage, do not disassemble
hub or shell require replacement. Replace the bearing if
the clutch shell and hub assembly unless the bearing,
With the sprocket side up, remove Figure 6-21. Clutch Hub Retaining Ring
ers and could be propelled with enough force to cause
ing retaining rings. Retaining rings can slip from the pli-

CLUTCH PACK AND BEARING

1WARNING
1WARNING
CAUTION
Complete Disassembly 1. CLUTCH PACK ONLY. disassembled. serious eye injury. (00312a) Figure 6-21. See 2. retaining ring from clutch hub groove. d0355x6x

CLEANING AND INSPECTION

1WARNING 1WARNING Compressed air can pierce the skin and flying debris from compressed air could cause serious eye injury. Wear safety glasses when working with compressed air. Never use your hand to check for air leaks or to deter- Wash all parts in cleaning solvent, except for friction plates and bearing, if removed. Blow parts dry with low Blow off all lubricant from the friction plates. Do not Measure the thickness of each plate with a dial cali- If the thickness of any plate is less than 0.143 in. (3.62 mm), discard all friction plates and replace Look for worn or damaged fiber surface material NOTE Replace all nine friction plates with

mine air flow rates. (00061a) pressure compressed air. Check friction plates as follows: wipe off with a rag. per or micrometer. with an entirely new set. (both sides). before installation. Check the steel plates as follows: 0.006 in. (0.15 mm). rough or binds or has any end play. worn or damaged. 2006 Softail: Drive

HOME 1. 2. a. b. c. d. 3. a. b. 4. 5. 6. 7. exists. 6-14