Page 16 - EOSedge installation Documents

EOS 90395-A-PHY-0002-Column feet assembly & setting

d. Inject the adhesive one hole at the time
and have a second person insert the

anchor bolt inside the hole. You may
want to pull the anchor back out from
time to time to make sure there is
enough adhesive covering its entire
length. A bit of adhesive overflow when
the anchor is pushed all the way in may
be a good indication there is enough

adhesive in the hole.

e. Repeat the process to all remaining
holes and when done, allow the
adhesive mix cure for at least one full
hour.

f. After the hour has passed, carefully
clean the Nivell plate from any leftover

adhesive and hand-tight all 16 bolts for now.

g. You have completed floor anchoring preparation for the primary side