Page 27 - ST Sept
P. 27

WELDING                                                                                                  WELDING

    Findings

            1. Analysis of the presented video images confirmed the effectiveness of the proposed
    technique for researching fast processes accompanying melting and transfer of electrode metal
    in gas-shielded arc welding with a consumable electrode.
            2. The quality of the images of the contours of the transferred droplets increases in the case
    of an increase in the generation of the power of laser coherent radiation while simultaneously
    filtering the obtained images using special light filters.
    3. Special WeldStat software has been developed, which allows processing the oscillograms of
 a  b  c  the main energy parameters of the mode and performing the subsequent statistical processing

    of the characteristics of heat and mass transfer.













 d  e  f



 Fig. 3. Video frames of melting and transfer of electrode metal into the weld pool at different intervals of the welding
 microcycle using a CuBr laser.




    In the course of experimental studies, it was found that the operation of the laser creates
 interferences that affect the equipment recording the energy parameters. These interference   Yu. N. SARAEV, Dr. Tech. Sciences, Associate Professor,
 complicates the analysis of the obtained oscillograms of the arc current and voltage. Typical   A.G. LUNEV, Cand. tech. sciences;
 oscillograms under interference conditions are shown in Figure 4a.                    M.V. TRIGUB, Cand. tech. sciences;
                                                                                  M.V. PEROVSKAYA, Cand. tech. sciences;
                                                                               (IPPM SB RAS, Tomsk, IOA SB RAS, Tomsk)
                                                                                                          Yu. N. Saraev.

                                                                                                               i-mash.ru














    References:

    1. Ehlers S., Шstby E. Increased crashworthiness due to arctic conditions –The influence of sub-zero temperature // Marine
    Structures. 2012. Vol. 28. pp. 86-100.
    2. Physical and technical problems of modern materials science. In 2 volumes.Vol. 1. / editorial board: I.K. Walking, etc.;
 Fig. 4. Oscillograms of arc current and voltage during laser operation in video mode: a - before processing, b - after image   NAS of Ukraine. Kiev: Akademperiodika, 2013. 583 p. ISBN 978-966-360-235-6. ISBN 978-966-360-236-3.
 processing.  3. Ogino Y., Hirata Y. Numerical simulation of metal transfer in argon gas-shielded GMAW // Welding in the World.  2015. Vol.
    59, iss. 4. pp. 465–473. doi: 10.1007 / s40194-015-0221-8.
    To filter the oscillograms of the arc current and voltage from pulsed laser interference, as   4. Influence of the soft zone on the strength of welded modern HSLA steels / F. Hochhauser, W. Ernst, R. Rauch, R. Vallant, N.
    Enzinger // Welding in the World. 2012. Vol. 56, iss. 5-6. pp. 77–85.
 well as their statistically processing in order to obtain energy parameters, a special WeldStat   5. Prospecting studies of increasing the reliability of critical metal structures operating under extreme loads and low climatic
 software was developed, which allows:  temperatures / Yu.N. Saraev, S.V. Gladkovsky et al. // Science-intensive technologies in the projects of the Russian Science
    1) provide reading of files of oscillograms of arc current and voltage recorded by digital   Foundation. Siberia / ed. S.G. Psakhye and Yu.P. Sharkeyeva. Tomsk: Publishing house NTL, 2017. Ch.5. pp. 134–202.
    6. Copper bromide vapor brightness amplifiers with 100 kHz pulse repetition frequency / M.V. Trigub, G.S. Evtushenko, S.N.
 oscilloscopes manufactured by Aktakom and Owon, perform filtering from interference (filtering   Torgaev, D.V. Shiyanov, T.G. Evtushenko // Optics Communications. 2016. Vol. 376. pp. 81–85.
 result in Figure 4b);  7. Saraev Yu.N. Substantiation of the concept of improving the safety and survivability of technical systems operated in the
    2) carry out visual viewing and scaling of current and voltage oscillograms;  regions of Siberia and the Far North, based on the use of adaptive pulse welding technologies. // Heavy Machine Building.
    2010. No. 8. pp. 14-19.
    3) perform statistical processing of oscillograms with obtaining data on average current,   8. Study of the influence of energy parameters of the arc welding mode with coated electrodes on the stability of heat and
 average  voltage,  average  amplitude  of  short-circuit current,  average  short-circuit duration,   mass transfer / Yu.N. Saraev, A.G. Lunev, A.S. Kiselev, A.S. Gordynets, D.A. Nesteruk, A.A. Khaidarova, D.A. Chinakhov, V.M.
 coefficient of variation of current and short-circuit duration, average arc power [8].  Semenchuk // Welding production. 2018. No. 2. pp. 3-13.



 26  Stanochniy park                                                                            Stanochniy park      27
   22   23   24   25   26   27   28   29   30   31   32