Page 57 - 2020 Allstar Performance Parts and Equipment Catalog
P. 57
CHASSIS
Chassis Tie Down Brackets Ford 9" Truss Support ALL68330
ALL60075 Weld-on support
Steel brackets weld to chassis adds strength to
and provide a secure mounting rear axle housing
location to hook a tie down strap or and reduces unwanted
winch cable. Package of 2. flex during extreme torque.
Constructed of 12 gauge (.108") steel. 36" L x 2" W.
Transmission Mount Bracket Leaf Spring Pad ALL56126
ALL38072 Steel pad welds to 3" diameter rear end
axle tube when mounting rear end to
May be welded to chassis to support
manual or automatic transmissions. most leaf springs. Pad is 2-1/2" W by 5-3/4" L and has a
Steel bracket is 1/8" thick with 1" x 7/16" 5/8" center pilot hole. Sold each.
slots for mounting bolts.
Lower Spring Cups
Steel spring cup has a 7" wide
Driveshaft Loop curved base that welds to the top
ALL56124
ALL69000 of a 3" diameter rear NEW
end axle tube cre-
Universal Lightweight
driveshaft loop contains ating a flat mounting Version!
the driveshaft if a yoke or surface for a 5" O.D.
U-joint fails. Loop is 1/4" thick x 2" wide racing springs. Commonly used
mild steel and fully adjustable to fit most cars. to replace OE style “pigtail” lower
spring mount. Sold each. ALL56123
ALL56124 ..... Standard Cup
ALL56123 ..... Lightweight Cup NEW!
Driveshaft Loop
For 1979-2004 Mustangs ALL69006 Leaf Spring Slider Box
Driveshaft safety loop bolts-on ALL60034
to help retain the front of the
driveshaft in the Leaf spring slider box replaces
event of a U-joint conventional leaf spring shackles
or other drivetrain compo- to enable effortless suspension
nent breakage. Black epoxy coated, movement and prevent binding. Box
all steel loop includes mounting hardware may be welded, or bolted directly to chassis
and complete instructions. Loop is designed to fit and includes two nylon bushings with spring mounting
inside factory tunnel and work with most driveshafts up hardware. Fits 2-1/2" wide Chrysler type leaf springs.
to 4" in diameter. Replacement Bushings ALL99055
Leaf Spring Slider Box
Unwelded Driveshaft Loop ALL60035
ALL69004 Replace rear leaf spring shackles
Made from 3/16" flat steel, loop with Allstar’s leaf spring slider box.
is 9-1/2" tall, 5-1/2" wide with a Bolt-in slider box with roller bearing
16" wide mounting strap that design eliminates leaf spring binding, freeing
can be cut and welded for each installation. up car. Fits 2-1/2" wide Chrysler type leaf springs.
Adjustable Panhard Bar
180° Driveshaft Loop ALL69002 Mounting Bracket ALL60185
Pre-bent 1" diameter x .083" wall mild steel Bracket welds onto the rear of a 3" steel axle
tubing is designed for chassis style cars to help tube to mount a Panhard bar behind the axle
retain the driveshaft in the event of a U-joint housing. A machined 6" slot with a sliding
failure. Loop is 10" tall overall and has a 5" I.D. retainer nut makes it possible to change roll
center by adjusting Panhard bar angle with
only one wrench. Bracket includes a 3" x 3/4"-10 bolt, two
5/16" wide spacers and a flat washer.
www.allstarperformance.com 55
