Page 393 - Chief Architect Reference Manual

Wall Specification Dialog

1 The Default Wall Heights settings selected wall and the floor and ceiling
allow you to reset a wall’s default top platforms above and below it. These settings
and bottom heights if they have been only take effect when the selected wall is
manually edited. See “Wall Heights” on page positioned at a platform edge, such as at the
369. exterior of a building or Open Below room.
• Default Wall Top Height and Default • Select Stop at Ceiling Above to have the
Wall Bottom Height are only enabled if top of the wall stop at the bottom of the
the selected wall’s top and/or bottom ceiling platform above.
height has been edited. Check these boxes • Select Balloon Through Ceiling Above
to restore the default heights. to have the top of the wall go past the ceil-

2 The Platform Intersection settings ing platform. If there is a wall directly
control the relationship between the above, the framing will continue upward

393