Page 11 - Kondor® KL 1 - E-1063 Programming and Operation Manual
P. 11

®
                      KL1: 1063 PROGRAMMING AND OPERATION


                      Chapter 1 Operator Interface/Standard User Screens


                      User

                          User / Jog

                                           E-1063                           Screen Key
                                                               ·  Carriage Backward: Jogs the carriage towards
                                                                 the entrance while pressed
                                                               ·  Carriage Forward: Jogs the carriage towards the
                                                                 exit while pressed
                                                               ·  Slow Forward: Jogs the carriage towards the exit
                                                                 slower than Carriage Forward while pressed
                                                               ·  Spray Arm FWD: Jogs the arm clockwise if
                                                                 viewed from the top
                                                               ·  Spray Arm BWD: Jogs the arm counter-clockwise
                                                                 if viewed from the top
                             Encoder Proximity Switch Gap

                                    Slow Forward: has been provided to check proper carriage Encoder operation.
                                    Pressing the Slow Forward button first begins the Carriage moving slowly down the rails causing the gear in the
                                    Encoder to turn. The ovals next to “CARR ENCODER” fill from left to right and clear from left to right.
                                    If the oval fill/clear pattern is not according to the above, first check wiring. A typical fix if pattern is reversed is to
                                    swap Proximity Cables on the Encoder.
                                    Pressing and holding the SLOW FWD button will cause the display to appear for A and B Phase Encoder on times.
                                    The proximity sensors should be adjusted until these are nearly identical.
                                    Target  Gap  Distance  will  show  on  the  HMI  (E-1063  Human  Machine  Interface)  Jog  Screen.  If  needed  make
                                    adjustments by moving the Proximity Switch “IN”  or “OUT” until the gap distance numbers below are achieved.
                                    Remember to Push in the Emergency Stop Button if you are going into the Carriage to make adjustments!
                          User / Monitor Inputs
                                           E-1063                     Screen Key
                                                              ·  The ovals are ON/OFF
                                                                indicators.
                                                              ·  A filled oval indicates that an
                                                                Input is ON.









                          User / Monitor Outputs

                                           E-1063                     Screen Key
                                                              ·  The ovals are ON/OFF
                                                                indicators.               ENU – Entrance Door Up
                                                                                          ENS – Entrance Door Stop
                                                              ·  A filled oval indicates that an
                                                                Output is ON.             END – Entrance Door Down
                                                                                          EXU – Exit Door Up
                                                              ·  Some Outputs are namable and   EXS – Exit Door Stop
                                                                will not be the same as names   EXD – Exit Door Down
                                                                indicated to the left.





                       1MANUL126                 Belanger, Inc.® * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681                 1-3
   6   7   8   9   10   11   12   13   14   15   16