Page 35 - Wave Wrap™

WAVE WRAP™

Maintenance

Trouble Shooting

Problem Solution
• See initial startup section (Adjusting Limit
Wrap Head does not walk up the boom Switch)

• Increase pressure as needed (see Adjusting Air
Regulators)
• See initial startup section (Adjusting Wheel
Speed)

Wrap Head does not follow the vehicle • See initial startup section (Adjusting Flow
Control)

• Increase pressure if movement is too slow,
decrease if movement is too fast
• See initial startup section (Adjusting Limit
Switch)
• See initial startup section (Adjusting Limit
Switch)

• Check for missing pieces or damaged cleaning
Wobbling Boom or Shaft material

• Check Bearings for wear
• Check for bent shaft

Boom not pivoting inward • Confirm output is set to “AUTO” position
• Verify air feeds are in proper location
• Confirm that air is working properly on both
sides of air cylinder, rebuild or replace if
necessary

Brush is turning too slow • Confirm flow control setting is all the way
open
• Confirm hydraulic unit has 1000 – 1100 PSI

• Replace motor on hydraulic unit

Note: The pressure settings stated are for Conveyor speeds of approximately 100 vehicles per
hour. Different pressure settings may be needed to compensate for different Conveyor
speeds.

1MANUL864 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 33