Page 34 - Tunnel Support Components

TUNNEL SUPPORT COMPONENTS

Installation

Solution Delivery Module (SDM) General

Water Valves
There are three types of water valves available.

Foaming Style Water Valve Injector Style Water Valve for Rinse Style Water Valve for Rinse
(Fresh water ONLY!), Chemical Dispensing, and/or Undercarriage Wash
Part #VLV FOAMING Part #VLV INJECTOR (Water ONLY, NO chemicals),
Part #VLV RINSE
The solenoid valves and the pumps require 110VAC.
Chemical Pumps

The Pulsatron™ pump can be either Hyper
Concentrate or Super Concentrate. It has two Fluid output
adjustment knobs located on the pump face and Priming line
one priming bypass control located on the base Bypass Feed back
of the fluid output line. Of the two knobs on the to chemical
face of the chemical pump, the larger one drum
regulates the pumps stroke length, whereas the DO NOT
smaller knob alters the stroke rate (cycles per ADJUST THIS
minute). KNOB
Stroke UNLESS THE
To prime the pump, fully open the bypass Length PUMP IS
knob. This will shorten the fluid path and allow RUNNING
the chemical to loop directly back into the Stroke
chemical drum. Once the pump has been 110VAC Rate
primed, close the bypass knob. Feed

For best results, the drying agents and sealer
waxes should use 100% stroke rate. To alter the
chemical usage, adjust the stroke length.
When using super concentrated chemicals, a Concentrate Pump will be required to regulate the chemicals
properly.

Pump Cover

The pumps are mounted directly on the Triple Foam Panel frame
and concealed behind a plastic protective cover. There is a tab
provided to place a padlock for security to prevent unauthorized
chemical adjustments. To access the pumps you will need to flex
the plastic cover over the tab. Use a padlock so secure settings.

Padlock tab

32 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL760