Page 18 - Triple Foaming Sticks

TRIPLE FOAMING STICKS

Maintenance

Manifold Gasket Replacement
If for any reason the gaskets need to be replaced on the stated pieces of equipment, the
following guidelines can make the task more manageable.
Note: When moving a Triple Manifold Arch, always replace the gaskets.

1) Spray WD-40 or equivalent on the threads of all screws. This will remove dirt and other
contaminants that get into the exposed threads. For screws at the top and the bottom

Apply lubricant
to all exposed
threads before
attempting to
loosen (typical)

Note: Use only a good 3/32” Allen wrench that does not have rounded corners. Do not use a
ball end Allen wrench, as the ball will probably break off making removal extra difficult.
On the Triple Manifold Arch corner blocks, the long red T-Handled Allen wrench
supplied with the arch should be used.

2) Tap on the end of the wrench to unseat any corrosion between the stainless screw and the
aluminum manifold. Loosen and remove all 4 screws.
Insert an Allen Wrench into socket
heads and tap on the ends (typical)

16 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUAL753