Page 19 - Triple Foaming Sticks

TRIPLE FOAMING STICKS

Maintenance

Manifold Gasket Replacement
3) Clean and inspect each location where surfaces meet for any scratches or nicks. File smooth if
necessary.
Note: If there are any deep grooves in either surface a gasket sealer such as “Permatex™” may
be needed.
4) Install the new gasket, being careful not to pinch it.
5) Install all 4 screws with even torque, repeating the sequence at least twice.
6) After waiting about 5 minutes for the gasket to relax and flow, re-torque all 4 bolts again. Make
sure there are no external loads on the joint, such as a Titan VPS™ feed line or water feeds that
can cause undo stress on the joint.
7) Turn on the piece of equipment and inspect for any leaks.
8) Retighten all screws if necessary.
9) If a torque wrench is available, use the following torque specifications:
Titan end cap and feed block 120 in/lbs.
Triple Foam end cap and feed block 120 in/lbs.
Triple Arch end caps 120 in/lbs.
Triple Arch corner blocks 90 in/lbs.

1MANUAL753 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 17