Page 55 - FreeStyler® E-1063 Programming and Operation Manual
P. 55
E-1063 PROGRAMMING AND OPERATION
Chapter 5 Operator Interface/Advanced Configuration
Setup / Advanced Configuration
Advanced Configuration / Exit Wheel Setup
Screen Key
The following selections move you to their corresponding
screens
• ADVANCED CONFIGURATION
• OUTPUT NAMING
• OUTPUT “ON WITH” CONTROL
• ENTER WHEEL SETUP
• TOP WHEEL SETUP
• EXIT WHEEL SETUP
MONITOR RETRACT: The oval toggles from filled to un-filled. When filled the system will Fault if the Arms are
being instructed to open and either of the Out-Position Read Sensors are not on.
FROM FRONT: Indicates that the Application started at the exit of the bay (front of the vehicle). The following
fields control Exit Wheel behavior when they are started From Front.
ENABLED / DISABLED CHECK NEXT PASS
• When ENABLED the Exit Wheels will stay on and in until next pass is started.
• If next pass does not utilize Exit Wheels, the Enter Wheels will go out and turn off.
• If next pass does utilize Exit Wheels, they will remain in and on for uninterrupted operation
ON POSITION IF TOP WHEEL ON
• This is the amount of inches from the front of the vehicle that the Exit Wheels will turn on and
move in if the Top Wheel is on for that pass.
ON POSITION IF TOP WHEEL OFF
• This is the amount of inches from the front of the vehicle that the Exit Wheels will turn on and
move in if the Top Wheel is not on for that pass.
FROM FRONT IN MOTION DELAY
• This is the amount of seconds that the Carriage motion will be delayed after Exit Wheels are
instructed to come in when the pass has started FROM FRONT.
FROM BACK: Indicates that the Application started at the entrance of the bay (back of the vehicle). The
following fields control Exit Wheel behavior when they are started FROM BACK.
ENABLED / DISABLED CHECK NEXT PASS
• When ENABLED the Exit Wheels will stay on and in until next pass is started.
• If next pass does not utilize Exit Wheels, the Exit Wheels will go out and turn off.
• If next pass does utilize Exit Wheels, they will remain in and on for uninterrupted operation
FROM BACK IN MOTION DELAY
• This is the amount of seconds that the Carriage motion will be delayed after Exit Wheels are
instructed to come in when the pass has started FROM BACK.
ENABLED / DISABLED SPEED SHIFT
• When ENABLED and the machine is within the preset speed shift position from the front of
vehicle the machine will slow down.
• SPEED SHIFT SPEED: This is the speed that the Carriage will travel when SPEED SHIFT is active on
the back of the vehicle. Displayed in Hz. Value is relative. Smaller values produce slower speeds.
1MANUL224 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 5-9