Page 53 - FreeStyler® E-1063 Programming and Operation Manual
P. 53

E-1063 PROGRAMMING AND OPERATION


                       Chapter 5 Operator Interface/Advanced Configuration


                       Setup / Advanced Configuration


                           Advanced Configuration / Enter Wheel Setup
                                                                          Screen Key
                                                            •









                                MONITOR RETRACT: The oval toggles from filled to un-filled. When filled the system will Fault if the Arms are
                                being instructed to open and either of the Out-Position Read Sensors are not on.

                                FROM FRONT: Indicates that the Application started at the exit of the bay (front of the vehicle). The following
                                fields control Enter Wheel behavior when they are started From Front.
                                   ENABLED / DISABLED CHECK NEXT PASS
                                       •   When ENABLED the Enter Wheels will stay on and in until next pass is started.
                                         •   If next pass does not utilize Enter Wheels, the Enter Wheels will go out and turn off.
                                         •   If next pass does utilize Enter Wheels, they will remain in and on for uninterrupted operation

                                   ENABLED / DISABLED ANTI SKUNK
                                       •   When ENABLED the Enter Wheels will perform “Anti-Skunk” motion at the rear of the vehicle
                                          when started FROM FRONT.
                                         •   ANTI SKUNK DISTANCE: This is the amount of inches after Enter Passenger Side In (Input / X35) in on
                                            that the carriage will continue to travel backward. Once the Carriage has traveled this far backward, it will
                                            move passenger side arm out, move the driver side in and then move forward 10 inches before finishing
                                            pass.
                                   FROM FRONT IN MOTION DELAY

                                       •   This is the amount of seconds that the Carriage motion will be delayed after Enter Wheels are
                                          instructed to come in when the pass has started FROM FRONT.

                                   ENABLED / DISABLED SPEED SHIFT
                                       •   When ENABLED and the machine is within the SPEED  SHIFT  POSITION  from  the  back  of
                                          vehicle the machine will slow down.
                                         •   SPEED SHIFT POSITION: This is the amount of inches from the back of the vehicle that the Carriage
                                            will slow down to allow the Enter Wheels more time on the back of the vehicle.
                                         •   SPEED SHIFT SPEED: This is the speed that the Carriage will travel when SPEED SHIFT is active on
                                            the back of the vehicle. Displayed in Hz. Value is relative. Smaller values produce slower speeds.


















                       1MANUL224                     Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681                    5-7
   48   49   50   51   52   53   54   55   56   57   58