Page 51 - FreeStyler® E-1063 Programming and Operation Manual
P. 51

E-1063 PROGRAMMING AND OPERATION


                       Chapter 5 Operator Interface/Advanced Configuration


                       Setup / Advanced Configuration


                           Advanced Configuration / Application Configuration














                            Back Distance: Position from back of the vehicle that the speed change will occur.
                            This position separates “MID” and “BACK” speeds.
                            MID and BACK speeds are set in the “Package Setup” area.
                            Front Distance: Position from front of the vehicle that the speed change will occur.
                            This position separates “FR” and “MID” speeds.
                            FR and MID speeds are set in the “Package Setup” area.
                            Back = None: Touch the screen in this area to select the function installed on the entrance end of the machine.
                            If “WHEELS” is selected, Entrance Side Wheels will operate for that application.
                            Front = None: Touch the screen in this area to select the function installed on the exit end of the machine.
                            If “WHEELS” is selected, Exit Side Wheels will operate for that application.
                            Center = None: Touch the screen in this area to select the function installed on the center area of the machine.
                            If “TOP WHEEL” is selected, Top Wheel will operate for that application.
                              Note:  Top Wheel will not operate if application begins at the entrance of the wash.

                            High Pump (YES/NO): When toggled to YES, that application will run the high-pressure pump. This is typically for
                            HydroBlade™ Rinse. Setting not necessary for tire  high-pressure, it will run pump independent of application
                            settings.
                            Truck Mode Offset 000: When a NAMED Output has TUCK MODE ENABLED (TM = YES instead of TM = < >), the
                            Output will turn OFF between the back of the truck and the position where the Sonar detected the drop from cab
                            height. This setting allows adjustment of the OFF POSITION relative to the measured back of the cab position. A
                            positive number in this field moves ON/OFF position toward the back of the pick-up truck.





















                       1MANUL224                     Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681                    5-5
   46   47   48   49   50   51   52   53   54   55   56