Page 17 - Full Side Washer Signature® Series

FULL SIDE WASHER Signature ® Series

Installation

Positioning the Stands (Legs)

Note: When determining equipment placement, be sure to measure the distance from the next piece of
equipment leaving room for the boom to pivot.. Before positioning the leg assemblies, insert the leveling
bolts and tighten until flush with the bottom surface of the base plates. This will prevent cement dust from
getting in the treads.
1) Position the Passenger side Stand Assembly at the desired tunnel depth on the floor and
measure from the inside of the inside guide rail to the back of the passenger side base
plate. It is to be placed at a distance of 107” as shown below.
2) Position the driver side Stand Assembly at the desired tunnel depth on the floor and
measure from the inside of the inside guide rail to the back of the driver side base plate. It is
to be placed at a distance of 59” as shown below.

Vehicle
Travel
107"

59"

1MANUL856 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 13