Page 18 - Foam-X® Spray Arch

®
FOAM-X SPRAY ARCH

Installation

Bell-Hose and Wear Strip
1) Locate the components for the Bell-Hose and plastic Wear Strip assembly as shown
below.

Rubber Bell Hose
108264 (2): 1CLAMP373
Floor Mounts
Plastic Wear Strip

108264 1CLAMP373

The plastic Wear Strip will slow down the wear of the hose against the cement floor as
vehicles roll over it.
2) Lag the Wear Strip and Floor Mounts to the floor at the locations shown above.

3) Once lagged to the floor, secure the Bell-Hose to the two Floor Mounts realizing it will
need to be stretched and cut-to-fit. Secure it into place using the supplied clamps.

The completed assembly should appear as shown below.

Note: Connect one end of the hose to one of the mounts then stretch the hose and cut to
length. Secure that end in place with a clamp. Now stretch the hose to the other mount
and clamp into place.
A field supplied 1/4” poly-flow tube is to be run from the one mount to the pressure
switch.
4) The two floor mounts will be secured to the floor. The one in the middle of the tunnel will
have a plug installed in the end and the other one will have a 1/4” push-in tube fitting
installed

5) The Bell-Hose is to be secured to the floor at 6” before the applicators. It only has to be
across half of the bay since only one of the tires is required to run over the hose and

16 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL215