Page 19 - QuickFire® Wrap Around Signature® Series

QUICKFIRE® Signature ® Series

Installation

Positioning the Stands (Legs)

Note: When determining equipment placement, be sure to measure the distance from the next piece of
equipment leaving room for the boom to pivot. Before positioning the leg assemblies, insert the
leveling bolts and tighten until flush with the bottom surface of the base plates. This will
prevent cement dust from getting in the treads.

1) Position the Passenger side Stand Assembly at the desired tunnel depth on the floor and
measure from the inside of the inside guide rail to the back of the passenger side base
plate. It is to be placed at a distance of 103-1/2” as shown below.
2) Position the driver side Stand Assembly at the desired tunnel depth on the floor and
measure from the inside of the inside guide rail to the back of the driver side base plate. It is
to be placed at a distance of 49-1/2” as shown below.

Driver Side

Vehicle
Travel

49-1/2"

103-1/2"
Passenger Side

Driver Side Passenger Side

49-1/2" 103-1/2"

3) The two Stand Assemblies are to be offset 78-1/2” as shown below.

78-1/2"

1MANUL826 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 15