Page 22 - QuickFire® Wrap Around Signature® Series

QUICKFIRE® Signature ® Series

Installation

Installing the Booms

Note: When installing the Sizer Disc, be sure NOT to allow the Anti Seize™ to smear and come
between the Pivot Post and the Sizer Disc.

4) Locate the 9/16-12 x 2-1/2” bolts, lock washers, nuts and the Sizer Plates (shown below).
The four bolts that hold the lower Bearing to the Stand will also hold the Sizer Plate in place.
The bolts on the top Bearing are to come down through the Boom’s Top Pivot-Plate. The
bolts on the bottom Bearing must pass through the Sizer plate and
up through the Boom’s Bottom Pivot-Plate.

5) Lift the Boom into place making sure that the Grease Fittings on the
Bearings are facing the exit of the tunnel.
Install all fasteners into place and tighten all fasteners on the
Bearings. Now snug all of the Bearing Set-screws. Sizer Plate

Boom Top Pivot-Plate

Bottom Bearing with Bolts
Temporarily in Place

Boom Bottom Pivot-Plate

Bolts down
through
Pivot-Plate.
Lock Upper Bearing
washers and
nuts are on Bolted in Place
the Bearing Sizer Plate
side.

Bolts up through Sizer Plate and
Sizer Plate
Bottom Pivot-Plate. Lock washers
and nuts are on top of the Bearing.

Driver Side Complete (view from underside) Passenger Side Complete (view from underside)

18 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL826