Page 22 - Pivoting Wheel Stinger™ Mix and Match

PIVOTING WHEEL STINGER Mix and Match

Installation

Utility Connections

1) Locate the Fluid Coupling Assemblies and secure them to the upper
frame as shown below. They can be installed on either the entrance or
exit side of the frame although we recommend the entrance side.

Before After

Fluid Coupling
Assemblies

1) Locate the two 1" hydraulic hoses and the Fluid Coupling Assemblies (shown on previous page) and attaché
them to the upper cross beam as shown below.
Keep in mind that all remaining parts to complete the water circuit are field supplied.

2) Secure the other end of the hoses to the field supplied water feeds as determined by the installer. The
images below are a typical example of a single pump application.

All connecetions All connecetions
from here up are from here up are
field supplied field supplied

When running water lines
Driver side Passenger side from the Pumping Platform
to supply the Pivoting
Wheel Stinger™, keep in
mind the GPM you will
require and reference the
“Water Chart” shown in the
startup section of this
document for appropriate
pipe sizing.

20 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (810) 349-7010 * Fax (810) 380-9681 1MANUL586