Page 46 - Top Wheel Signature® Series

SignatureSignature SeriesSeries
TOP WHEEL SignatureSignature ® SeriesSeries

Maintenance

Torque Plate and Electric Motor Replacement

The wiring to each motor will have to be removed in order to gain access to the bottom of the
gearbox. There you can inspect and change the flat head bolts used to mount the torque plate.

DANGER

DISCONNECT MAIN POWER SUPPLY PRIOR TO SERVICING
OR MAINTAINING EQUIPMENT

Remove Motor Gearbox assembly
1) Turn off the power and place the disconnects in the OFF position. To ensure safety we recommend following the
Lock out procedure stated above for the main panel prior to servicing the equipment.
If the assembly does not have a cover, proceed to step 3
2) Remove both Phillip head screws, to allow plastic cover to be removed from cover base.

Remove Phillip Head Screws

3) Verify power has been removed from circuit by checking voltage at the junction box with a multi-meter to confirm
no power is being supplied to the equipment.
4) Remove the junction box cover to gain access to motor wiring.
5) Remove the nuts to release wiring from the terminal block.

6) Verify wiring has been tagged for proper terminal connections if not previously identified at original installation.

42 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL752