Page 47 - Top Wheel Signature® Series

SignatureSignature SeriesSeries
TOP WHEEL SignatureSignature ® SeriesSeries

Maintenance

Torque Plate and Electric Motor Replacement

Remove Motor Gearbox assembly

7) Disconnect wiring leads, and remove electric feed
Wires are located behind the terminal
strip and will need to be pulled
through the cord grip fitting on the
bottom of the junction box.
The cord grip will need to be
loosened, or removed so that
the wiring can be pulled down
through the cover base if
equipped.

8) Remove torque stud retainer pins and washers. This will allow the motor gearbox assembly to be removed by
pulling the assembly straight up and off of the torque studs and off the wheel shaft.

Move the motor gearbox assembly to a work surface and turn it over to expose the bottom of the cover
and the cover mounting plate if so equipped. You will need a work surface such as a table or a bench
available to allow for disassembly of the gearbox torque plate.
If the assembly does not have a cover proceed to step 10

9) The cover base can be removed by removing the three fasteners on the cover mount plate. Once the cover
mount and cover are removed it will allow access to the bottom of the gearbox torque plate assembly.

10) Using a 5 mm Allen wrench; remove the four fasteners to separate the torque plate and mounting ring from the
gearbox to expose the mounting holes on the gearbox.

1MANUL752 Belanger, Inc. * 1001 Doheny Ct. * Northville, MI 48167 * Ph (248) 349-7010 * Fax (248) 380-9681 43