Page 22 - Wave Across™ Signature® Series

WAVE ACROSS™ Signature ® Series

Maintenance

Routine Procedures

Daily
 Start every washday with a “Test Wash” to insure proper operation of all equipment.
 Inspect the component for clogged nozzles. This can best be done while running the “Test
Wash” in the morning. Nozzles can be cleaned by removing the nozzle bodies and tapping
or inserting a thin wire into the nozzle opening.
 Dump any water that has settled in the air compressor or install a timed pump valve (not
supplied).
 Check operation to insure uniform foam is being applied where applicable. This is best be
checked while running the “Test Wash” in the morning.
 Check the chemical injection pump(s) to insure that the pump is properly primed if
applicable. This is done by checking the chemical inside of the clear supply tubing. There
should be no bubbles or breaks in the fluid (if applicable).
 Check overall performance for any abnormalities on the first few vehicles washed each day.
 Hose down the component and surrounding area at the end of each washday. This will
remove the majority of the dirt and other debris that builds up during a washday.
 Check for water and chemical leaks after equipment is turned off.

Weekly
 Check all mixing tanks periodically for sludge build-up on bottom. If too much sediment is
evident, drain tank and clean (if applicable).

Monthly
 Wash component down with a good degrimer such as Tide laundry detergent and hot water.

Quarterly

 Scrub down powder coated and e-coated portions of the component with plastic scrubbing
pad. Scrub down aluminum portions with a fine steel wool such as S.O.S. pads and wash
with good degrimer such as Tide laundry detergent and hot water (whenever using steel
wool on aluminum, always follow the grain to prevent scratching the finish).

Semi-Annually
 There is a grease fitting located on the gearbox opposite of where the electric motor
mounts. This fitting is there so the shaft bearing can be greased, because there is not
enough splash from the ring gear to lubricate the bearing.

 It is recommended that one squirt of a general-purpose grease be applied every six months.

18 Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL851