Page 114 - FreeStyler® Maintenance Manual

®
MAINTENANCE

Chapter 3 General Repairs

Spot Free (RO)

3000 GPD Stand Mounted RO System Utility Requirements

Requirements 23” 24” Top View
Water
 1” (25.4 mm) water line with
Ball Valve, 20 GPM @ 30 36”
PSI (75.7 LPM @ 2.1 BAR)
for RO System
 Drain
Electrical
 Two, 220V, 20 Amp, single
phase circuits, each with its
own L6-20 locking
receptacle. Place this plug
60” (154.4 cm) up from the 72” Front View
floor on the right side of the 64”
RO unit.
100 Gallon
Tank

Re-pressurization Pump
The purpose of the Re-pressurization pump is to re-pressurize the water from the holding tank and deliver it to “Spot-
Free” rinse. See the illustration below.
Note: On a stand-mounted unit, the re-pressurization pump is already mounted on the frame.

 Attach the provided 3/4” hose from the outlet of the pump to the manifold.
Note: On the pump control box is an open 1/2” flexible conduit connector containing a black
wire, a white wire and a red with black tracer wire.

 From your controller, run wires from output 06 to the black and from 110V common to
the white.
Note: The red with black is intended for low water notification and is not currently in use.

3-50 Belanger, Inc.® * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL222