Page 46 - Sudzer® BL & FM
P. 46

®
            SUDZER  BL & FM



            Chapter 3 Sudzer® BL Installation

            Sudzer® BL Startup

               Initial Startup Procedures
                   1)  Working  with  a  local  chemical  supplier  set  the  chemical  to  water  ratio  in  the  delivery
                       system to the desired setting.

                   2)  Close  the  Sudzer®  BL  air  plenum  vent  which  is  located  on  the  end  of  the  driver  side
                       plenum assembly.
                   3)  Using the controller force on the function(s) for the fan, lights and chemical delivery.
                   4)  Turn  the  air  regulator  up  that  feeds  the MixStir® pump to 80psi and inspect the entire
                       machine for bubbles. The bubbles should be coming out of all the nozzle tips at about the
                       same consistency. If one or more of the tips are not passing fluid, turn off the functions to
                       inspect and clean the spray nozzles. Make sure that there are no water leaks at any of the
                       hose connections or nozzles.
                   5)  After inspecting the Sudzer® BL and confirming there are no leaks and that bubbles are
                       coming out of all of the nozzle tips you can adjust, in any order, the following:
                         The ratio of the chemical/water mixture. Try to find the best combination of settings
                          that will produce the desired bubble but uses the least amount of chemical. This can
                          be  done  by  changing  out  the  tips  that  are  supplied  with  the  HydroMinder  on  the
                          MixStir®.
                         There are two different nozzle kits offered with the Sudzer® BL: A 3.0gpm kit or a
                          4.5gpm kit. The MixStir® can put out up to 5.0gpm. Adjust the air regulator that feeds
                          the MixStir® pump to the proper setting based on the nozzle kit installed.
                         During the installation of the Sudzer® BL nozzles the 3D mesh media bubble disks
                          were installed. The media disks can be switched to the coarse media bubble disks if a
                          different style bubble is desired.
                         This Startup Procedure began with the Air Plenum Vent closed this will allow all of the
                          air from the fan to pass thru the nozzle outlets. The vent can be opened at this time to
                          achieve the desired amount and consistency of bubbles.
                         The speed of the fan was wired to high capacity. If you need to change the speed to
                          low capacity you must re-wire the fan, be sure to turn off all power to the bay before
                          rewiring.
                   6)  After all of the settings have been adjusted run a few test washes on various vehicles to
                       confirm that the desired bubble consistency and volume has been obtained.
























            1MANUL026         Belanger, Inc. * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681     3-20
   41   42   43   44   45   46   47   48   49   50   51