Page 38 - Kondor® KL 2 - E-1063 Programming and Operation Manual

®
KL2: 1063 PROGRAMMING AND OPERATION

Chapter 4 Operator Interface/Advanced Configuration

Setup / Advanced Configuration

Advanced Configuration / Application Configuration
ON Positions
FS = From Start (turns ON based upon the start position of the application).
FE = From End (turns ON based upon the end position of the application).

Examples:
· FS 000 – Will turn ON immediately when application is started.
· FS 002 – Will turn ON at 2 inches from the position that the application is started.
· FE 002 – Will turn ON at 2 inches from the position that the application will eventually
stop.
· FE 050 – Will turn ON at 50 inches from the position that the application will eventually
stop.

Note: Outputs must be ON with “FS 000” in order to be ON during Fill Time.

OFF Positions
FS = From Start (turns OFF based upon the start position of the application).
FE = From End (turns OFF based upon the end position of the application).
Examples:

· FS 050 – Will turn OFF at 50 inches from the position that the application started.
· FE 000 – Will turn OFF at the end position of the application.
· FE 050 – Will turn OFF at 50 inches from the position that the application will eventually
stop.

· FE 999 –OFF position disabled lets the application shut the Output OFF when the
application is done.

WP:
WP toggles between (YES / NO). WP stands for Water Purge. It is typically used when a WAX
or SPOT FREE is run through the 25HP pump. This function turns OFF the corresponding
output during the B/F in Motion in order to flush solution out of the pump and immediate
plumbing before the end of the application. A typical consequence of this function not being set
properly is the wax being dispensed out of the Rocker Spin Cleans as the vehicle enters the
bay.

Note: OFF position should almost always be set to FE 999.

NORMAL PURGE / PURGE ALL PASS:
This toggles to PURGE ALL PASS to purge the entire application. This setting is to purge while
the machine is moving before the On-Board Dryer. It works for AC4 only.

4-4 Belanger, Inc.® * PO BOX 5470 * Northville, MI 48167-5470 * Ph (248) 349-7010 * Fax (248) 380-9681 1MANUL128