Page 23 - Funksjoner SCAFFPLANNER - NO

Scaffold Area

This function adds area elements outside the scaffolds. Lower level is 200 mm below the height just
handle on the base plates. Upper level is at highest ledger at top deck. Each time the function is ran it
removes existing area elements and adds new.

In that sense this is not actually a calculation tool. The total area of these area elements is reported
in the schedule “Scaffold area”. If you don’t have this schedule, it can be found in the supported
template in programdata folder.

The area elements are Generic families of name “ScaffoldArea” and belongs to the sub category
“Scaffold Area”

You can control the visibility of these elements in Visibility Graphics, Model Categories.