Page 351 - Foton Workshop Manual - Auman EST-M

Diagnosis - Diagnosis-fault diagnosis of electronic and electrical parts DI - 297

S/N Symbol Name Description IN

While the turn signal lamp is turned on, the instrument turn signal indicator
DI
lamp and turn signal lamp will flicker at the same time and the combination

Turn signal indicating instrument buzzer will beep continuously. While the turn signal lamp is
1
lamp turned off, the instrument turn signal indicator lamp and turn signal EG
lamp will be off and the combination instrument buzzer will stop beeping.
CAN wire signal.
TR

Rear fog indicating When the ignition switch is placed at "ON" position, the rear fog lamps will
2
lamp be on if the rear fog lamps is turned on. CAN wire signal AX

Low beam lamp When the ignition switch is placed at "ON" position, the high beam indicator
3 FR
indicator lamp will be on if the high beam lamp is turned on. CAN wire signal.

After the key switch is started in cold day, if engine ECU thinks that the air
ST
intake heater is necessary for the ambient condition, the engine ECU will
4 Pre-heating indicator
automatically start the air intake heater for heating and at the same time light
this lamp. CAN wire signal. BR

Front fog lamp When the ignition switch is placed at "ON" position, the front fog lamps will
5 BW
indicator be on if the front fog lamps is turned on. CAN wire signal

While the ignition lamp is placed at "ON" position, the indicator lamp will
EL
Engine emission be on; after the engine is started, the indicator lamp will be off if the
6 malfunction indicator engine works normally; if the aftertreatment system is abnormal, this

lamp lamp will keep on; at this time, it is necessary to go to repair station for
troubleshooting. CAN wire signal.

When the ignition switch is placed at "ON" position and the safety belt is
7 Safety belt indicator
not worn, the indicator lamp will keep on. Hard wire signal.

Fuel water separation When the water level in oil-water separator is higher than design value, the
8
alarming lamp indicator lamp will be on. CAN wire signal.

When the door is not closed, the door-unclosed warning lamp will be on.
Alarming lamp for
9 When the door is not closed and the vehicle speed is greater than 10km/h, the
door not closed
buzzer will beep intermittently. Hard wire signal.

When the ignition switch is placed at "ON" position, the battery charging
Battery charging
10 indicator lamp will be on; after the engine is started, the battery charging
indicator lamp
indicator lamp will be off. Hard wire signal.

Air filter alarming When the air intake system is not smooth, the air filter blocked warning
11
lamp for blocking lamp will flicker. Hard wire signal.

DI-297