Page 1104 - Foton Workshop Manual - Aumark (BJ1099)

34-74 AXLE AND PROPELLER SHAFT - CARDIN JOINT

(c). Press 4 needle bearings and dust shield by
hand, from the outside of the flange yoke
and the axle tube yoke. Install the cross
bearing from the inside of the fork joint
and the axle tube yoke. Knock the needle
bearing with hammer and copper rod and
install the 4 needle bearings and dust
shield in place.
NOTICE:
• Replace a new dust shield.
• Install them as marked.

(d). Install 4 spring snap rings with circlip pliers.
(2WD)
NOTICE:
• Replace new spring snap rings.
• After the installation, rotate the universal
joint with hand. The rotation shall be free of
stagnation.

• Install 4 spring snap rings with circlip pliers.
(4WD)
NOTICE:
• Replace new spring snap rings.
• After the installation, rotate the universal
joint with hand. The rotation shall be free of
stagnation.

fuwx34187

6. Install the transmission shaft assembly (Refer to "Chapter 34 Axle & Transmission
Shaft -Transmission Shaft Assembly,Replacementl")

Page 1104