Page 1103 - Foton Workshop Manual - Aumark (BJ1099)

AXLE AND PROPELLER SHAFT - CARDIN JOINT 34-73

(d). Measure the clearance between the cross
bearing and the needle bearing with jawed
vice and dial indicator.
Clearance:0.01~0.06mm
If the clearance exceeds the limit, replace
a new cross bearing and a new needle
bearing.

NOTICE:
Don't directly hold the cross bearing with jawed vice. Wrap the interface with soft cloth,
to avoid damaging the cross bearing. Insert the cross bearing into the needle bearing,
move the needle bearing in radial direction and measure the clearance between the cross
bearing and the needle bearing.

(e). Measure the radial clearance of the cross
bearing with dial indicator.
Clearance:0.1~0.3mm
If the clearance exceeds the limit, replace
a new cross bearing and a new needle
bearing.
NOTICE:
Attach the needle bearings onto the crossing
shaft, place into the mounting hole of universal
joint fork, install the snap rings on two sides,
move the crossing shaft axially, and measure the
axial play of crossing shaft.

5. Assemble the transmission shaft intermediate cardin joint 34
(a). Apply some grease on the mounting surface of the cross bearing and the needle bearing.
NOTICE:
• Apply some grease, as long as it covers the mounting surface of the cross bearing andthe
needle bearing.
• Overly grease may cause difficulty in the next steps.
(b). Install the fork joint and the axle tube yoke as marked.

Page 1103