Page 1105 - Foton Workshop Manual - Aumark (BJ1099)

AXLE AND PROPELLER SHAFT - MIDDLE BEARING 34-75
MIDDLE BEARING

SERVICING
1. Remove the rear transmission shaft assembly (Refer to "Chapter 34 Axle &
Transmission Shaft - Transmission Shaft Assembly, Replacement(2WD)”)
2. Disassemble the propeller shaft universal joint (refer to “Chapter 34 Axle and
propeller shaft - Servicing, universal joint”).

3. Remove the middle bearing rubber
backing ring & bracket assembly.
(a). Remove the nut.
NOTICE:
The removed nut shall not be further used.

fuwx34192

(b). Take down the plain washer.

fuwx34193

(c). Make the mounting mark on the propeller 34
shaft spline shaft and the joint fork.
NOTICE:
•Make sure that the mounting mark is clear.
•Confirm that various universal joints of the
propeller shaft are in the same direction.

fuwx34194

Page 1105