Page 1102 - Foton Workshop Manual - Aumark (BJ1099)

34-72 AXLE AND PROPELLER SHAFT - CARDIN JOINT

(c). Elevate one end of drive shaft and lightly
hammer the flange fork with a hammer
to shake off one needle bearing block.
Overturn the drive shaft for 180º and shake
off another needle bearing from the flange
fork as per same method.

(d). Secure the crossing shaft, elevate the drive
shaft, and lightly knock the root of the shaft
tube fork with a hammer to shake off the
needle bearing. Overturn the drive shaft for
180º and shake off another needle bearing
as per same method.
(e). Remove the Cross Bearing.

4. Check the cross bearing
(a). Check the wear on the surface of the cross
bearing journal.
(b). Measure the cross bearing journal with
micrometer.
Standard: 18.440mm
Limit: 18.425mm
If the wear exceeds the limit, replace a new
cross bearing.

(c). Measure the clearance between the needle
bearing and the cardin fork joint with dial
indicator.
If any clearance, replace a new needle
bearing and a new cardin fork joint.
NOTICE
Place the needle bearing into the mounting hole
of the cardin fork joint, move the needle bearing
in radial direction and measure the clearance
between the needle bearing and the cardin fork
joint.

Page 1102