Page 1135 - Foton Workshop Manual - Aumark (BJ1099)

AXLE AND PROPELLER SHAFT - DRIVING GEAR 34-105
DRIVING GEAR

CHECKING

1. Check the pre-tension of the differential
bearing
(a). Tighten the nut.
Torque : 217N•m

(b). Measure the driving gear startup tightening
torque with a Torque wrench.
StartupTorque : 1.5~2.6N•m
NOTICE:
Don't unscrew the nut to reduce the startup
Torque.
NOTICE:
• If the startup Torque exceeds the limit, replace
the driving gear bearing sleeve. (Refer to
"Chapter 34 Axle & Transmission Shaft - Driving
Gear, Overhaul")
• If the startup Torque is below the limit, take the
following actions.

(c). Further tighten the nut.
Torque (increase) : 5N·m 34
Torque (max.) :217N•m

fuwx34056

Page 1135