Page 1132 - Foton Workshop Manual - Aumark (BJ1099)

34-102 AXLE AND PROPELLER SHAFT - REAR DIFFERENTIAL ASSEMBLY

(b). Install the differential assembly.

(c). Measure the thickness of the differential
bearing spacer.
If it exceeds the limit, replace a new spacer.
(Refer to "Chapter 34 Axle & Transmission
Shaft - Rear Differential Assembly, Overhaul")

(d). Measure the distance bettween the main
reducer housing and the mounting end of
the differential bearing on the differential
housing.

(e). Install the differential bearing spacer.
NOTICE:
If no replacement, install it by left/right as marked.
Ensure the spacers on both sides have the same
thickness.
NOTICE:
The thickness of the differential bearing spacer
should be 0~0.02mm greater than the distance
derived in Step .

Page 1132