Page 1133 - Foton Workshop Manual - Aumark (BJ1099)

AXLE AND PROPELLER SHAFT - REAR DIFFERENTIAL ASSEMBLY 34-103

19. Install the differential bearing cap
(a). Put the differential bearing caps in place as
marked.
NOTICE:
Install them as marked.

(b). Tighten the retaining bolts of the differential
bearing cap.
Torque : 95~122N•m

20. Measure the driven gear runout
(a). Rotate the driven gear by hand.
(b). Measure the runout on the mounting
surface of the driven gear with a dial
indicator.
If the runout exceeds the limit, replace
a new one. (Refer to "Chapter 34 Axle
& Transmission Shaft - Rear Differential
Assembly, Overhaul") 34

21. Check the engagement mark of the driving and driven gears (Refer to "Chapter 34
Axle & Transmission Shaft - Rear Differential Assembly, Checking & Adjustment")
22. Check the pre-tension of the differential bearing (Refer to "Chapter 34 Axle &
Transmission Shaft - Rear Driving Gear, Checking")

Page 1133