Page 1128 - Foton Workshop Manual - Aumark (BJ1099)

34-98 AXLE AND PROPELLER SHAFT - REAR DIFFERENTIAL ASSEMBLY

(b). Remove the planetary gear shaft with
hammer and copper rod.

(c). Remove the planetary gear shaft sleeve.
half axle gear, planetary gear and thrust
washer.
NOTICE:
Carefully store the half axle gear, planetary gear
and thrust washer. Mark the directions and store
them separately.

(d). Measure the radial clearance between the
planetary gear and the planetary gear shaft
with jawed vice and dial indicator.
If the radial clearance exceeds the limit,
check the wear of the planetary gear and
the planetary gear shaft and replace them
if needed. (Refer to "Chapter 34 Axle &
Transmission Shaft - Differential Assembly,
Overhaul")
NOTICE:
Hold the planetary gear shaft with jawed vice
after wrapping it with soft cloth, or it may cause
damage.
(e). Measure the radial clearance between the
half axle gear and the differential housing
with jawed vice and dial indicator.
If the radial clearance exceeds the limit,
check the wear of the half axle gear and
the differential housing and replace them
if needed. (Refer to"Chapter 34 Axle &
Transmission Shaft - Differential Assembly,
Overhaul")

Page 1128